The old debate of whether Bonsai is Art or Horticulture is actually a non-event as we all by now know that a dead tree cannot be designed as a Bonsai and be admired as a living sculpture. We need both. The tree must be kept alive and sculpted to enable the Bonsai within to be shown.
I am in the process of re-reading a lot of my quite sizable Bonsai library. The majority of these books and magazines focus on the Art side of Bonsai cultivation. It is rare to find a good solid article or chapter in a book, dedicated to the Horticulture involved in Bonsai development. A quick search on the Internet shows more of the same. There is a bit more to be found on the Internet, but a lot of this is not necessarily linked to Bonsai specifically. A few examples are of importance here.
The first to mention is the practice of defoliation. When we remove the leaves from a tree, we drastically reduce the level of transpiration (loss of water through leaves), which is an important process supporting the flow of water through a plant. Partial defoliation obviously does the same, but just less. Then there is the practice of leave cutting. This will reduce the surface area of the leaves, which in turn will also have a reduced transpiration level as an outcome. Photosynthesis levels will also drop. There are very good reasons why we do this in the cultivation of Bonsai, but it is a process rarely seen in the cultivation of other plants.
Another of our Bonsai specific activities is the process of deadwood carving or carving in general. Deadwood is dead and nothing much needs to be taken into consideration except for aesthetic principles. When we carve into living wood, things change a bit. Tree tissues are laid down in layers. On the outside we have bark and under this we have the phloem, the tissue that conduct the nutrients produced in the leaves through photosynthesis. The next layer is the cambium. This tissue is responsible for the secondary growth in stems as well as roots. The next layer is the xylem. This tissue transports water from the roots to the leaves. Then we get to the lignin. These are dead cells and make up what we refer to as “wood”. This is the stuff we carve. To get to the lignin, we have to go through the living layers. This needs to be done carefully as we are interfering with some very important processes when we start carving. Not only do we interrupt the flow of nutrients and water, we directly impact on growth. This works well for us as well, as the cambium layer is the one that will help with the healing on the edges of the carving.
My advice is for Bonsai enthusiasts to read and learn about the science behind our activities as well. Not only will this knowledge help to keep more trees alive, it will help us understand the design process and principles better as well.